OSMO Polyx Oil 3054 Application Instructions (Pine Flooring)

***Read and understand all instructions before beginning it will save you time and elbow
 Coverage 250 Sq. Ft. Per Liter

Download Instructions pdf


  • Sand floor to no finer than 120Grit


  • Vacuum Floor to remove all Sanding Dust
  • Wipe floor with a tack cloth to remove any residual dust
  • Vacuum Floor once more to ensure dust removal
  • Wipe Floor down with High grade mineral spirits. (This step is critical with Southern Yellow Pine Floors)


  • Open Finish and Stir Well making sure all wax that has settled to the bottom of the container is mixed in. (Do not Shake)
  • Decide how much area you are comfortable covering. We recommend starting with a smaller area and working your way up if this is your first time, since working the finish into the wood is imperative. (simple but imperative)
  • Using Chart measure out your desired amount of Finish.
  • Pour desired amount of finish into a separate container large enough to accommodate your Floor Brush or Roller.
  • Try to only pour what is needed and do not work directly from the finish container. This will cause leftover finish to have a shorter storage life.

Approximate Floor Area to Cover Measured Amount per Coat

15 sq. ft. ¼ cup
20 sq. ft. 1/3 cup
30 sq. ft. ½ cup
60 sq. ft. 1 cup

Start Finishing

  • Always start in a corner where you can back out of the room so you do not have to walk on the freshly finished floor.
  • Dip the brush into the finish about ¼” deep. Do not overload the brush
  • Starting about 6-10” from the wall so you do not puddle finish at the base board. (If finish puddles at the base board use a business card to pull finish back so it can be worked in with a brush)
  • Work in finish with a scrubbing motion back and forth with firm pressure on the brush. Polyx Oil is a penetrating finish and DOES NOT BUILD A FILM. Work the finish into the floor until there is no finish left. If you see brush marks, keep working the finish around. All finish should be
  • worked into the wood and none left when completed, wood should be dry to touch. (If necessary use disposable rags to remove excess finish)
  • Allow 8-12 hrs for the first coat to dry before applying the second coat.
  • Apply Second Coat the same as the first coat. No sanding is necessary unless to repair blemish or buildup. If build up is found it must be removed before applying the second coat. Buildup is caused by an over application of finish.
follenwood in Walnut Grove, MS on Houzz